Photoroom_20260214_105449.png
Photoroom_20260214_105501.png
Photoroom_20260214_105404.png
Photoroom_20260214_105427.png
Photoroom_20260214_105438.png
Photoroom_20260214_105449.png
Photoroom_20260214_105501.png
Photoroom_20260214_105404.png
Photoroom_20260214_105427.png
Photoroom_20260214_105438.png

Mono subwoofer amplifier — 800 watts RMS at 2 ohms LC-1.800

$949.95

Power galore

Two keys to unlocking great sound in a car stereo system are serious power and extensive control — and this amp's got them both. For power, AudioControl's LC-1.800 mono subwoofer amp puts out up to 800 watts RMS, so it'll make your subwoofers happy. The adjustable low-pass and fixed subsonic filters make sure your sub gets only the frequencies it was designed to play, while AudioControl's AccuBASS® circuit ensures that your bass sounds great.

Active controls

Most factory radios turn down the lower frequencies as you turn the volume up in order to minimize stress on inexpensive factory speakers. AccuBASS eliminates this bass rolloff, so you get maximum bass performance when you add aftermarket amps to a factory radio. Onboard LEDs indicate optimized signal flow for inputs and outputs, plus give you a warning when a source is too loud and causing distortion. An optional wired remote lets you control bass volume from the front seat.

Works in almost any system

AudioControl designed the LC-1.800 to work equally well with aftermarket and factory stereos. Speaker-level inputs allow you to connect to almost any factory radio. Signal sensing circuitry turns the amp on via the speaker-level inputs, so you won't need to run a remote turn-on wire throughout your vehicle.

Power galore

Two keys to unlocking great sound in a car stereo system are serious power and extensive control — and this amp's got them both. For power, AudioControl's LC-1.800 mono subwoofer amp puts out up to 800 watts RMS, so it'll make your subwoofers happy. The adjustable low-pass and fixed subsonic filters make sure your sub gets only the frequencies it was designed to play, while AudioControl's AccuBASS® circuit ensures that your bass sounds great.

Active controls

Most factory radios turn down the lower frequencies as you turn the volume up in order to minimize stress on inexpensive factory speakers. AccuBASS eliminates this bass rolloff, so you get maximum bass performance when you add aftermarket amps to a factory radio. Onboard LEDs indicate optimized signal flow for inputs and outputs, plus give you a warning when a source is too loud and causing distortion. An optional wired remote lets you control bass volume from the front seat.

Works in almost any system

AudioControl designed the LC-1.800 to work equally well with aftermarket and factory stereos. Speaker-level inputs allow you to connect to almost any factory radio. Signal sensing circuitry turns the amp on via the speaker-level inputs, so you won't need to run a remote turn-on wire throughout your vehicle.

  • Product info:

    • mono subwoofer amplifier

    • 500 watts RMS x 1 at 4 ohms (800 watts RMS x 1 at 2 ohms)

    • Class D amp technology

    • AccuBASS® circuitry for improved bass response

    • MILC™ (Maximum Input Level Control) LED optimization and clip indicators

    • variable low-pass filter (30-230 Hz, 24 dB/octave)

    • fixed subsonic filter: 24 Hz

    Other Features:

    • preamp and speaker-level inputs

      • GTO™ (Great Turn On) signal-sensing turn-on with speaker-level input

    • optional wired remote level controller available

    • fuse rating: 40A x 2

    • wiring and hardware not included with amplifier

      • 4-gauge power and ground leads recommended

    • dimensions: 9-1/16"W x 2-1/8"H x 7-13/16"D

  • Performance

    • RMS Power Output: 500 W × 1

    • Peak Power Output: N/A

    • Power @ 2 Ohms: 800 W × 1

    • Power @ 1 Ohm: Not specified

    • Bridged Power: N/A

    • Minimum Impedance (Unbridged): 2 Ω

    • Frequency Response: 0 Hz (Not specified)

    • Total Harmonic Distortion (THD): 0.01% @ RMS power

    • Signal-to-Noise Ratio: 102 dB

    • Input Voltage: Not specified

    Features

    • Amplifier Class: Class D

    • Built-in DSP: No

    • Remote Control: Optional

    • Low-Pass Crossover: 30–230 Hz

    • Low-Pass Slope: 24 dB/octave

    • High-Pass Crossover: N/A

    • High-Pass Slope: N/A

    • Bass Boost: AccuBass

    • Bass Boost Frequency: Not specified

    • Cooling: Passive (no fan)

    • Fuse Rating: 80 A

    • Speaker-Level Inputs: Yes

    • Preamp Outputs: No

    Physical Dimensions

    • Width: 9-1/16 in

    • Height: 2-1/8 in

    • Depth: 7-13/16 in