

















Prime Series Mono - 500 watts RMS x 1 at 2 ohms R2-500X1
Primed for Performance, the R2-500X1 is a 500 watt, class-D amplifier capable of operating at 4Ω or 2Ω mono. This amplifier is extremely efficient because of its Class-D technology which reduces demand on the vehicles electrical system. The amp also features C.L.E.A.N. circuitry to help you adjust your gain settings, a P.O.W.E.R. supply that generates more power as voltage increases, and integrated Punch EQ that corrects for acoustic deficiencies while delivering up to 3X the bass. Perfect for subwoofers, a variable infrasonic filter and remote level control allows you to tune the bass for the desired level for the music.
Primed for Performance, the R2-500X1 is a 500 watt, class-D amplifier capable of operating at 4Ω or 2Ω mono. This amplifier is extremely efficient because of its Class-D technology which reduces demand on the vehicles electrical system. The amp also features C.L.E.A.N. circuitry to help you adjust your gain settings, a P.O.W.E.R. supply that generates more power as voltage increases, and integrated Punch EQ that corrects for acoustic deficiencies while delivering up to 3X the bass. Perfect for subwoofers, a variable infrasonic filter and remote level control allows you to tune the bass for the desired level for the music.
Primed for Performance, the R2-500X1 is a 500 watt, class-D amplifier capable of operating at 4Ω or 2Ω mono. This amplifier is extremely efficient because of its Class-D technology which reduces demand on the vehicles electrical system. The amp also features C.L.E.A.N. circuitry to help you adjust your gain settings, a P.O.W.E.R. supply that generates more power as voltage increases, and integrated Punch EQ that corrects for acoustic deficiencies while delivering up to 3X the bass. Perfect for subwoofers, a variable infrasonic filter and remote level control allows you to tune the bass for the desired level for the music.
-
mono subwoofer amplifier
300 watts RMS x 1 at 4 ohms
500 watts RMS x 1 at 2 ohms
CTA-2006 compliant
Class-D amplifier design
variable low-pass filter (50-250 Hz, 12 dB/octave)
variable bass boost (0-18 dB at 45 Hz)
variable subsonic filter (15-40 Hz, 12 dB/octave)
More Info:
C.L.E.A.N. gain setup system includes clip lights
wired remote Punch Level Control included
auto remote turn-on
preamp and speaker-level inputs
preamp outputs
wiring, fuse, and hardware not included with amplifier
4-gauge power and ground leads and an 80-amp fuse recommended
dimensions: 8-1/2"W x 2"H x 7-3/4"D
-
Performance
RMS Power Output (Watts x Channels): 300 x 1
Peak Power Output (Watts x Channels): N/A
Power at 2 Ohms (Watts x Channels): 500 x 1
Power at 1 Ohm (Watts x Channels): ---
Bridged Power (Watts x Channels): N/A
Minimum Impedance Bridged: N/A
Minimum Impedance Unbridged: 2
Best Frequency Response: 20-250 Hz
THD at Rated RMS Power: 1%
Signal to Noise Ratio: 75 dB
Input Voltage: 14.4v
Features
Amplifier Class: D
Built-in DSP: No
Remote Control: Yes
Low-Pass Crossover Frequency: 50-250 Hz
Low-Pass Slope (dB/octave): 12 dB/octave
High-Pass Crossover Frequency: N/A
High-Pass Slope (dB/octave): N/A
Bass Boost: 0-18 dB
Bass Boost Frequency: 45 Hz
Fan Cooled: No
Fuse Rating: 80
Speaker Level Inputs: Yes
Preamp Outputs: 2
Dimensions
Width (inches): 8-1/2
Height (inches): 2
Depth (inches): 7-3/4
-
Mono subwoofer amplifier
Wired Remote Level Control module
16' Remote cable (RJ-25 connector on both ends)
One 7" Speaker input harnesses
3mm Allen Hex key
Four 3/4" Screws
Two 1/2" Screws
5 Flat washers
1 Nut
Installation and Operation instructions (English/ French/ Spanish/ German/ Italian)
Certificate of Performance
Rockford Fosgate contact information