10inch Powered Hideaway Subwoofer 360 Watts Max 51HS10

$549.99

The Hideaway HS10 is a compact powered 10-inch subwoofer that delivers surprising low frequency impact in a tough, all-aluminum frame. KICKER innovates once again, with FIT+™ (Fail-safe Integration Technology PLUS). Accepting input signals ranging from a mere 0.25 volt to as high as 40 volts (400 watts at 4Ω) and fully compatible with newer vehicles using start/stop systems, the HS10 works with almost any vehicle on the road today without the added expense of a line output converter.

The Hideaway HS10 is a compact powered 10-inch subwoofer that delivers surprising low frequency impact in a tough, all-aluminum frame. KICKER innovates once again, with FIT+™ (Fail-safe Integration Technology PLUS). Accepting input signals ranging from a mere 0.25 volt to as high as 40 volts (400 watts at 4Ω) and fully compatible with newer vehicles using start/stop systems, the HS10 works with almost any vehicle on the road today without the added expense of a line output converter.

  • 🔧 General

    • Enclosure Type: Sealed

    • Finish Material: Aluminum

    • Grille: Metal Mesh

    • Connector Type: Harness

    • Quick-Disconnect Plug: Yes

    • Bi-amp Inputs: N/A

    • Woofer Size: 10"

    • Woofer Material: Not specified

    • Passive Radiator: No

    📏 Dimensions

    • Width: 9-7/8"

    • Height: 3-1/4"

    • Depth: 15"

    📊 Specifications

    • Frequency Response: 25 Hz – 120 Hz

    • Amplifier Power (RMS): 180 Watts

    • Maximum Power Handling: 360 Watts

    • Crossover Point: 50 – 120 Hz

    • Sensitivity: Not specified

    • Impedance: Not specified

    • Second Voice Coil Impedance: N/A

    • 10" Amplified subwoofer

    • Wiring harness (17' Power input/ 8' Speaker level input/ 2' Ground/ 2' Remote turn-on)

    • 12" Power wire with in-line fuse holder and installed 15A ATO fuse

    • Two 15A ATO fuses (1 installed in the chassis of the unit/1 spare)

    • Remote bass level control

    • 19.5' Remote cable (3.5mm TRS plugs on both ends)

    • 4 Mounting brackets

    • Four 3/4" pan head screws

    • Eight 1/4" counter-sunk screws

    • Two 3/8" screws

    • Two 10-12 gauge crimp-on ring terminals

    • One 10-12 Gauge butt connector

    • Owner's manual (En/ Sp/ Ge/ Fr)

You Might Also Like